We found this old cedar fencing on the free part of Craig’s
List. Hubby did pay the guy $20.00 to help him load it.
It has been sitting in the wood hoard since April. Here is how the project went up:
7:30 am We set up the table saw, carried 50 pieces of wood to the porch and got busy. We have had Ole Betsy, our table saw for more than 25 years and bought her used all those years ago.
Hubby got busy “Truing up” the boards. That just means he cut the boars all exactly the same width and straight by running both sides through the table saw. He cut about a 1/2 inch off each side.
Yes, I made him use a wood pusher but in this picture he was finished with the cut and I wasn’t able to take the picture and help him catch the wood.
8:30 am Hubby got busy cleaning the sawdust and I carried all the boards down to the fence to clean them. This should have been step one but we don’t do easy at our house. I used the jet spray choice on the sprayer It took off the dirt but an added bonus was that it took a lot of the silvery aging off the boards. I made sure not to leave lines from the sprayer but I really liked the results. The wood looked a lot more like barn wood and less like fencing.
9:30 am Hubby got out the compound miter saw ( chop saw) and, even though the wood was damp, he got busy cutting off the rotted ends and the dog-eared tops of the boards. That left a lot of different lengths of wood. We wanted a random pattern in the joints so we were happy with the wood left.
10:30 am We moved all the furniture to get started, went to borrow a stud finder and level… We left ours in the burbs. We removed the
crown moulding and baseboards,
11:00 am I decided to paint the wall behind the wood. I was concerned that the light wall would show through at knot holes or cracks. In the end, it was probably paint and time wasted, because Hubby did such a good job with the wood there were few gaps and none showed through. As soon as I finished painting Hubby marked a level line and marked the studs with tape ( I will tell you why later.)
12;00 pm At this point we realized we only had a few nails for the 18 gauge air stapler but decided to go ahead and get started. We decided to put the row up below the window first to make sure we had that row where we wanted it and level.
Hubby manned the air nailer and called out measurements. I found the wood and cut it to length. He was able to move the tape as he went along to keep up with where the studs were in the wall.
4:00 pm We ran out of staples. Bummer. At this pint we were hot, tired and grumpy. We cleaned up, moved stuff so we could sleep bathed then headed over our friends’ house for supper.
8:00 am Hubby went in search of nails. I cut the boards to go on either side of the window while he was gone.
10:00 am Nails were found and we could get back to work.
Well, some of us got busy. Others conked out on the floor and made us walk over them.
The wall went up quickly and we were able to get finished quickly.
2:00 pm The wall was finished! Enjoy the finished wall. I love the color.
Did you notice the door headboard? We finished it when I painted the French Provincial furniture, but I wanted you to see it on the wall first. It even has door knob- that it did not have when we bought it thanks to my friend, Tanis.
We are going to have mason jar lights on either side of the door bed and I am planning to make roman shades for the windows. I am trying to figure out what color bedding. Any suggestions?
What do you think friends? I love to hear from you.