We are clearing out the Garagemahal as we prepare to put our beloved Star Hill on the market. I am getting pressure from Mr. Math to get rid of the hoard. My collection of odd bits and parts, Doo dads, rusty metal, and miscellaneous hardware needs a new home. Mr. Math would be fine with the new home being the trash.

Not this girl.

Saturday morning I stood in the hoard and started looking at what I had to work with. I decided to make a standing chalkboard/ message board. (They need a better name and I am open for suggestions.) In fact while I was at it, I figured I may as well make six of them for the ladies at craft night.

I pulled out a set ls spindles from a table the social planner and I got off the road one day. It was a wreck when we got it but the spindles were solid wood so I saved them.

2015/02/img_2438.jpg

I pulled out my stash of hardware. I have quite a collection of odd handles, knobs and bits. Some of them I buy for pennies at thrift stores, garage sales, or ReStore but most come off pieces I redo and change the look.

I had a can of spray chalkboard paint in the cabinet. I have to admit that the spray chalkboard paint is not my favorite, but it works.

I grabbed two sections of 1X12 pine board that were shelves an a section of 1X1 moulding and a 2X6 board for the project.

supplies 1-IMG_0127

My sweet husband cut all the spindles down to the same size and then used the drill press to put a hole in the center of each top for a screw to go in.

I played with the parts until I came up with a plan.

I cut the pine board, the 1X1 moulding, and the 2X6 into 6 inch segments each.

connecting board

pine boards

The assembly process took both Mr. Math and me working. The steps were to connect the spindle to the 2X6 with wood glue and a screw, then connect the 1X1 to the other end of the spindle with a screw in the center.

1-IMG_0138 1-IMG_0136 1-IMG_0137

Two screws at each end of the 1×1 went into the 1 inch width of the 6 inch section of the 1X12,

A little wood glue, wood filler, and a quick spray of primer unified the four sections.

1-IMG_0140 1-IMG_0141

The whole thing got primed, painted with sea salt, then heavily distressed and glazed.

1-IMG_0142

1-IMG_0146 1-IMG_0147

I then taped off a chalkboard rectangle on each board then spayed them.

1-IMG_0152-001

While the chalkboards were drying, my friend the social planner helped me pick out some of the hardware and knobs to attach to the pieces.

1-IMG_0153

Do you remember the roadside end table? The handle from that piece made it onto a piece here.

20140615-141529-51329339.jpg

20140615-173740-63460586.jpg

So did some hardware from my windfall.

funky dresser hardware

Once the chalkboard was dry we attached the hardware to each piece and the social planner attached a clip with E6000 in case someone wanted to use it for invitations or photos.

Here they are ready for the party.

1-IMG_0158 1-IMG_0164 1-IMG_0166

The cost of this entire project was what I spent in screws, wood glue and paint. I am estimating I spent $10.00 total in supplies I will have to replenish.

These would be great table numbers at a wedding or on a buffet table  Here they are lined up for craft night.

1-IMG_0174

It was nice to see the craft group enjoying their surprise.

1-IMG_0186

When the ladies came in they got to put a tag on their chalkboard.  It was fun to see the different ones each chose.

Well, what do you think?

I love hearing from you,

Blessings,

Karen

Advertisements